Thursday, 14 December 2017

Drill Machine-Homemade

Drill:-

Drilling is a cutting process that uses a drill bit to cut a hole of circular cross-section in solid materials. The drill bit is usually a rotary cutting tool, often multipoint. The bit is pressed against the workpiece and rotated at rates from hundreds to thousands of revolutions per minute. This forces the cutting edge against the workpiece, cutting off chips (swarf) from the hole as it is drilled.
In rare cases, specially-shaped bits are used to cut holes of non-circular cross-section; a square cross-section is possible.

Drill Bit:-
Drill bits are cutting tools used to remove material to create holes, almost always of circular cross-section. Drill bits come in many sizes and shapes and can create different kinds of holes in many different materials. In order to create holes, drill bits are usually attached to a drill, which powers them to cut through the workpiece, typically by rotation. The drill will grasp the upper end of a bit called the shank in the chuck.

Drill bits come in standard sizes, described in the drill bit sizes article. A comprehensive drill bit and tap size chart list metric and imperial sized drill bits alongside the required screw tap sizes. There are also certain specialized drill bits that can create holes with a non-circular cross-section.

Chuck:-
chuck is a specialized type of clamp. It is used to hold an object with radial symmetry, especially a cylinder. In drills and mills, it holds the rotating tool whereas in lathes it holds the rotating workpiece. On a lathe, the chuck is mounted on the spindle which rotates within the headstock. For some purposes (such as drilling) an additional chuck may be mounted on the non-rotating tailstock.
To chuck, a tool or workpiece is to hold it with a chuck, in which case it has been chucked. Lathe work whose work holding involves chucking individual slugs or blanks is often called chucking work, in contrast to bar work or bar feed work. In bar work, the bar protrudes from the chuck, is worked upon, then cut off by a lathe tool (parted off) rather than being sawn off. Automatic lathes that specialize in chucking work are often called chuckers.

More videos for:-
Subscribe to my channel:-Romeo And Science


How to make a simple water indicator alarm at home


more videos for:-
Subscribe to my channel:-Romeo And Science

How To Make Best Paper Airplanes at Home

How To Make Best Paper Airplanes at Home


More videos for:-
Subscribe to my channel:-Romeo And Science


How to Make Mini Gas Jet Welding Using Lighter

How to Make Mini Gas Jet Welding Using Lighter:-

Gas-jet (up to 1000ºС) with your own hands!
With the turned on blowing the gas-jet has a good heating power, it can set alight a plumbeous pellet in a few seconds (up to 1000ºС)!

more videos for:-
Subscribe to my channel:-Romeo And Science

How To Make Origami Paper Fan

How To Make Origami Paper Fan

more videos for:-
Subscribe to my channel:-Romeo And Science

DIY Craft Ideas using Bulb for Home Decors

more videos for:-
Subscribe to my channel:-Romeo And Science

DC motor Free Energy supplying Generator – Self Running with Capacitor

Make Free Energy Generator Mini Best of World 2017 new Project 100 % Real Free Energy mini Generator new project use free energy any time 2 mini Motor and 1 fit Wire and gulo and 1 wood and Make Free Energy 100% Real
more videos for:-
Subscribe to my channel:-Romeo And Science